MIL-F-18327 Filters; High Pass, Low Pass, Band Pass, Band Suppression, And Dual Functioning, General Specification ForThis specification covers the general requirements for passive frequency-selective networks, such as dual functioning, band suppression, band pass, low pass, and high pass \(or any combination thereof\) electric-wave filters, including those employing electromechanical and piezoelectric elements, for use over the frequency range of 0 to 500 megahertz. Filters covered by this specification are intended for use where operation under various environmental conditions is required. This specification covers filters weighing not more than 50 pounds and requiring root-mean-square test voltage ratings not greater than 5,000 volts.

Pages 1 - 2 - 3 - 4 - 5 - 6 - 7 - 8 - 9 - 10 - 11 - 12 - 13 - 14 - 15 - 16 - 17 - 18

MIL-F-18327F

2. APPLICABLE DOCUMENTS

2.1 General. The documents listed in this section are specified in sections 3 and 4 of this specification. This

section does not include documents cited in other sections of this specification or recommended for additional

information or as examples. While every effort has been made to ensure the completeness of this list, document

users are cautioned that they must meet all specified requirements documents cited in sections 3 and 4 of this

specification, whether or not they are listed here.

2.2 Government documents.

2.2.1 Specifications, standards, and handbooks. The following specifications, standards, and handbooks form a

part of this document to the extent specified herein. Unless otherwise specified, the issues of these documents are

those cited in the solicitation or contract (see 6.2).

FEDERAL STANDARDS

- Screw-Thread Standards for Federal Services.

DEPARTMENT OF DEFENSE SPECIFICATIONS

Electron Tubes, General Specification for.

Enamel, Equipment, Light-gray (Formula No. 111).

DEPARTMENT OF DEFENSE STANDARDS

Test Methods for Electronic and Electrical Component Parts.

Environmental Test Methods.

Marking of Electrical and Electronic Parts.

Copies of these documents are available online at https://assist.daps.dla.mil/quicksearch/ or from the Standardization

Document Order Desk, 700 Robbins Avenue, Building 4D, Philadelphia, PA 19111-5094.)

2.3 Non-Government publications. The following documents form a part of this document to the extent specified

herein. Unless otherwise specified, the issues of these documents are those cited in the solicitation or contract.

INTERNATIONAL ORGANIZATION FOR STANDARDS (ISO)

Measurement Management Systems � Requirements for Measurement

Processes and Measuring Equipment � First Edition

(Copies of this document may be ordered online at https://www.iso.org or from the International Organization for

Standardization American National Standards Institute, 11 West 42 Street, 13 Floor, New York, NY 10036)

NATIONAL CONFERENCE OF STANDARDS LABORATORIES (NCSL)

Calibration and Measuring and Test Equipment � General Requirements

(Copies of this document may be ordered online at https://www.ncsli.org or from National Conference of Standards

Laboratories (NCSL), 2995 Wilderness Place, Suite 107, Boulder, CO 80301-5404)