MIL-PRF-15733/40C
A
B
C
D
E
F
G
H
Dash
No.
Min
Max
Min
Max
Min
Max
Min
Max
Min
Max
Max
Min
Max
±.015
0001
.375
437
.656
.718
469
.531
.187
.249
.172
.202
.234
.281
.343
.093
(9.53)
(11.10) (16.66) (18.21) (11.86) (13.49)
(4.75)
(6.32)
(4.37)
(5.13)
(5.94)
(7.14)
(8.71)
(2.36)
NOTES:
1. Dimensions are in inches.
2. Metric equivalents are given for general information only.
3. Circuit diagram for information only.
FIGURE 1. Dimensions and configuration (continued)
REQUIREMENTS:
Configuration and dimensions: See figure I.
Weight: 2.7 grams maximum.
Case: Not applicable (metallic mounting eyelet).
Terminals: Solderable (see figure 1). Pure tin finish is prohibited.
Operating temperature range: -55°C to +125°C.
Rated voltage: 500 V dc or 350 V rms to 400 Hz, over the operating temperature range.
Rated current: 25 amperes, dc or ac (rms).
Insertion loss: In accordance with MIL-PRF-15733 and table I.
Seal: Not applicable.
Capacitance to ground: In accordance with MIL-PRF-15733. Measured capacitance shall be at least 3,000 pF.
Temperature rise: +25°C, maximum.
Dielectric withstanding voltage: In accordance with MIL-PRF-15733. The following exception shall apply:
Test voltage: 1,500 V dc applied for 1 to 5 seconds.
Barometric pressure (reduced): In accordance with MIL-PRF-15733 and Method 105, MIL-STD-202; test
condition D.
Insulation resistance: In accordance with MIL-PRF-15733. Insulation resistance measured at 25°C between
either terminal and the case shall be at least 10 G ohms.
Voltage drop: Not applicable.
Overload: In accordance with MIL-PRF-15733. The following exception shall apply:
Measurements at +25°C after test: Insulation resistance shall meet initial requirements.
Terminal strength: In accordance with MIL-PRF-15733 and Method 211, MIL-STD-202; test condition A.
Applied force: 5 pounds.
2